Sterile horizontal benches for product contamination protection are constructed either in AISI 304 stainless steel or in epoxy powder painted steel. The wide choice of sizes and materials enables many different applications; each version is supplied with either stainless steel or nonreflective plastic laminate work surfaces.

APPLICATIONS
KBN horizontal laminar airflow benches can be used in a wide range of disciplines, including:

- Sterile manipulation
- Sterility tests
- Microbiology
- Preparation of ophthalmic solutions
- Preparation of culture media
- Assembly of equipment
- Floriculture
- TPN preparation
- Medical device assembly

SPECIFICATIONS
Construction: Corrosion resistant epoxy powder painted steel (as standard); glazed AISI 304 stainless steel (on demand)

Work Surface: AISI-304 stainless steel (as standard) or non reflective plastic laminate (on demand)

Transparent side walls: safety glass

Absolute filter: HEPA filter, tested with D. 0. P aerosol. Their efficiency, higher than 99.995% MPPS -0.005%penetration -ensures performance exceeding requirements of EN1822, U. S. Federal Standard 209 e, British Standard 5295, VDI-2083 and AS 1386-1979.

Pre-filters: synthetic fibers pre-filters washable in water or with compressed air, average arrestance 80/90%ASHRAE (CEN-G3); dust holding capacity 400 g/m2.

Motor-blower (s): direct coupled motor (s), electronic speed controlled to maintain a constant air flow of 0.45 m/sec, and compensate for a partially clogged filter, up to a maximum plenum pressure of 40 mm of water.

Power supply: 230 V -50 Hz, single phase. Other voltages on request.